This doesn't count as a project because it was just assembling something rather than building or installing, but people kept asking if I was going to do a blog post about it. To the right is what the table looked like for about 5 months. I didn't take a picture before I loaded the slate on, and I wasn't about to unload it just for a picture. The hardest part at this stage was deciding where to place the table in order to maximize the use of the gameroom without constricting play.
| I fabricated some floor shims out of a piece of poplar: |
|
Here's the table with slate loaded. I had to shim each slate level and even with the next, then cover the joints with water putty and sand them down, which created a lot of super fine dust.
Felt stretched across the slate:
Assembled and ready for play:
0 comments:
Post a Comment